Just make sure to use non-toxic wood and non-toxic finishes like Raw Linseed Oil or Carnauba Wax so that dangerous chemicals from other woods and finishes doesn’t contaminate the food that goes onto the cutting board. You can also opt to include an indent for the knife, so the chef can put the knife into the cutting board when the knife is not currently in use.
Woodworking is the art that gets you busy and you can do this activity in the leisure time. If you are new to the art of woodworking there is nothing to worry about. It is not so much difficult that you cannot learn. Remember, learning never stops. So, have the courage to start the art of woodworking and take your time out to learn it. Here I am sharing 20 woodworking projects with you, have a look at them in detail. I am sure you would get some good ideas for the woodworking projects of your home and office. With these woodworking projects, the beauty of your drawing and dining room would be enhanced. You should not lose hope while learning these woodworking ideas. By the time you would learn these projects very easily; if you work hard and concentrate, you can go for the further more complex projects.
I recently came across this beautiful wooden swing set, which was made in the shape of a boat. Cool, isn’t it? The very first look was enough for me to start loving it. Although I haven’t yet tried building one myself, I am definitely going to. Later I realized that you can also build a baby cradle with the same idea. After all, what can be more calming than the tender rocking of a boat? This swing set will surely help your child get more gentle sleep.
Cut off a 21-in.-long board for the shelves, rip it in the middle to make two shelves, and cut 45-degree bevels on the two long front edges with a router or table saw. Bevel the ends of the other board, cut dadoes, which are grooves cut into the wood with a router or a table saw with a dado blade, cross- wise (cut a dado on scrap and test-fit the shelves first!) and cut it into four narrower boards, two at 1-3/8 in. wide and two at 4 in.
Begin by cutting off a 10-in. length of the board and setting it aside. Rip the remaining 38-in. board to 6 in. wide and cut five evenly spaced saw kerfs 5/8 in. deep along one face. Crosscut the slotted board into four 9-in. pieces and glue them into a block, being careful not to slop glue into the saw kerfs (you can clean them out with a knife before the glue dries). Saw a 15-degree angle on one end and screw the plywood piece under the angled end of the block.