You can also create different style and design for DIY wood art. I think continuously that what should I use further for decoration than the idea came into my mind that I must try wood shelves. The procedure of making wood shelves is given in this link you just need to open this link so that you can see the procedure of making wood shelve for decoration purpose.
Working with reclaimed wood is a savvy use of resources, and the material's country appeal is undeniable. With just a saw and a small drill, you can reuse old fencing to make these simple woodworking projects: picket-inspired picture frames. Finish them off by hot-gluing clothespins or bulldog clips to hang your prints. Here’s a step-by-step guide.
These are indeed simple, and they look awesome to boot! I think I could make these look even nicer even better if I made some precision cuts for fine detailing. I was actually looking into that, and I found this page — the guy there says he was able to build a quality CNC router (for cutting) for about $300. Have you heard of the program he talks about? If you haven’t, no worries, but I thought I’d ask anyhow. Thanks again for these great beginner projects!
We cut the supports 16 in. long, but you can place the second shelf at whatever height you like. Screw the end supports to the walls at each end. Use drywall anchors if you can’t hit a stud. Then mark the position of the middle supports onto the top and bottom shelves with a square and drill 5/32-in. clearance holes through the shelves. Drive 1-5/8-in. screws through the shelf into the supports. You can apply this same concept to garage storage. See how to build double-decker garage storage shelves here.
With a pencil and a protractor, divide the larger disc into 30-degree wedges to create 12 center lines for the bottle indents. Center and trace the smaller disc on top of the larger disc. Next, with a drill press, drill 3/8-in.-deep holes on the 12 center lines with the 1-7/8-in. Forstner bit, spacing them between the disc’s outer edge and the traced circle. Next, divide the smaller disc into 60-degree wedges and drill six more 3/8-in.-deep holes with the Forstner bit.
×