Slice, dice and serve in style on this easy, attractive board. We’ll show you a simple way to dry-fit the parts, scribe the arc and then glue the whole thing together. We used a 4-ft. steel ruler to scribe the arcs, but a yardstick or any thin board would also work. Find complete how-to instructions on this woodworking crafts project here. Also, be sure to use water-resistant wood glue and keep your board out of the dishwasher or it might fall apart. And one more thing: Keep the boards as even as possible during glue-up to minimize sanding later. For great tips on gluing wood, check out this collection.
Make It: Help your child paint a square wooden dowel and wooden spool his favorite colors and allow to dry. Glue white string around the spool and adhere it near the bottom of the dowel. Attach a long string to the far end of the dowel and tie a magnet to the opposite end (magnetic barrels from the jewelry section of the craft store work well). Make clothespin "fish" by painting them fun colors with pink lips. Let paint dry and help your child glue on sequin scales and googly eyes. Now he'll be ready to go fishing!
Cut off a 21-in.-long board for the shelves, rip it in the middle to make two shelves, and cut 45-degree bevels on the two long front edges with a router or table saw. Bevel the ends of the other board, cut dadoes, which are grooves cut into the wood with a router or a table saw with a dado blade, cross- wise (cut a dado on scrap and test-fit the shelves first!) and cut it into four narrower boards, two at 1-3/8 in. wide and two at 4 in.
You would definitely want that your baby could get a good sleep in the cot, to fulfill your wish the cot should be very much comfortable. I have a made a baby cot that is the most amazing one and the comfortable one. I found this online it from wood. While going to bed, your baby really needs a sound sleep so that sleep can only get through a wooden baby cot. I am sharing some pictures of a different cot with you. Have a look at these pictures, you would like them.
Begin by cutting off a 10-in. length of the board and setting it aside. Rip the remaining 38-in. board to 6 in. wide and cut five evenly spaced saw kerfs 5/8 in. deep along one face. Crosscut the slotted board into four 9-in. pieces and glue them into a block, being careful not to slop glue into the saw kerfs (you can clean them out with a knife before the glue dries). Saw a 15-degree angle on one end and screw the plywood piece under the angled end of the block.