Furthermore, a lot of data can be gathered from the internet. So, here I am sharing some of the pictures with you from the internet. You can select the pictures of the knife stand which you think is the best one. It’s up to you to that which wall knife stand you select. You can then start your project and it is not a very difficult task to manage. So, have a look at these pictures and make up your mind.
Cut off a 21-in.-long board for the shelves, rip it in the middle to make two shelves, and cut 45-degree bevels on the two long front edges with a router or table saw. Bevel the ends of the other board, cut dadoes, which are grooves cut into the wood with a router or a table saw with a dado blade, cross- wise (cut a dado on scrap and test-fit the shelves first!) and cut it into four narrower boards, two at 1-3/8 in. wide and two at 4 in.
This particular tray is made using reclaimed barn wood but the author of the project Beyond The Picket Fence surprised everyone with one fact: reclaimed barn wood has often some areas turned pink due to cow urine. If you check the project more closely, you’ll also notice some areas of the tray being almost bright pink. That’s something you don’t see every day!

The clock is the sign of punctuality that is the main reason I am interested in making this wood project. Furthermore, I used pallet wood blocks to make the square shape of the wooden clock. You can make any shape of a wood clock like a square, rectangle. It depends on your making requirement Here is the link about making pallet wood clock, step by step procedure are shown in this video


With a pencil and a protractor, divide the larger disc into 30-degree wedges to create 12 center lines for the bottle indents. Center and trace the smaller disc on top of the larger disc. Next, with a drill press, drill 3/8-in.-deep holes on the 12 center lines with the 1-7/8-in. Forstner bit, spacing them between the disc’s outer edge and the traced circle. Next, divide the smaller disc into 60-degree wedges and drill six more 3/8-in.-deep holes with the Forstner bit.
×