The clock is the sign of punctuality that is the main reason I am interested in making this wood project. Furthermore, I used pallet wood blocks to make the square shape of the wooden clock. You can make any shape of a wood clock like a square, rectangle. It depends on your making requirement Here is the link about making pallet wood clock, step by step procedure are shown in this video
Just make sure to use non-toxic wood and non-toxic finishes like Raw Linseed Oil or Carnauba Wax so that dangerous chemicals from other woods and finishes doesn’t contaminate the food that goes onto the cutting board. You can also opt to include an indent for the knife, so the chef can put the knife into the cutting board when the knife is not currently in use.
Another wooden item that you should have in your own house is this DIY wooden Dog food table. Not so difficult to make, I made one for my dog and he is very happy after getting a treat from me. Believe it or not, this wooden dog food table has made my life easier and both dog and I are happy to get it. If you are a dog owner, this is a must have a wooden item and buying one would cost extra pennies.
Attention: Almost any do-it-yourself project involves risk of some sort. Your tools, materials, and skills will vary, as will the conditions at your project site. Reality Daydream has made every effort to be complete and accurate in the instructions of the plans on this website. Reality Daydream will not assume any responsibility or liability for damages or losses sustained or incurred in the course of your project or in the use of the item you create. Always follow the manufacturer's operating instructions in the use of tools, check and follow your local building codes, and observe all commonly accepted safety precautions.
With a pencil and a protractor, divide the larger disc into 30-degree wedges to create 12 center lines for the bottle indents. Center and trace the smaller disc on top of the larger disc. Next, with a drill press, drill 3/8-in.-deep holes on the 12 center lines with the 1-7/8-in. Forstner bit, spacing them between the disc’s outer edge and the traced circle. Next, divide the smaller disc into 60-degree wedges and drill six more 3/8-in.-deep holes with the Forstner bit.
×