Some tools required for this project are hole saw, drilling machine, pencil, tape measure, clamps, etc. This tutorial explains every step properly with images so that anyone can make a wooden sofa sleeve easily. Those, who prefer a video tutorial, can visit the below link to a YouTube video that illustrates the process of building a DIY Sofa Sleeve Cupholder.
With a pencil and a protractor, divide the larger disc into 30-degree wedges to create 12 center lines for the bottle indents. Center and trace the smaller disc on top of the larger disc. Next, with a drill press, drill 3/8-in.-deep holes on the 12 center lines with the 1-7/8-in. Forstner bit, spacing them between the disc’s outer edge and the traced circle. Next, divide the smaller disc into 60-degree wedges and drill six more 3/8-in.-deep holes with the Forstner bit.
The article explains step by step process for making this awesome piece of wooden art. Although it looks like a job for an intricate carpenter or woodcarver. But it is not. It is actually very easy to make one. All you need are a few pieces of wooden planks, a saw, screws, and plates. I must remind you here that a bit of woodworking skill is needed here too. So if it’s your first rodeo in carpentry, you might need some help from someone experienced. This DIY project is fun and a good sport at the same time. It is as easy on the eyes as it is to build one. If you don’t fancy writing instructions, here’s a video to help you understand its making.
Let’s take it up a notch and start building something more serious. This project may take more than just a few hours to complete, but the final item would be worth it as you can see in the image. It is a beautiful entryway table with drawers made entirely from scrap pallet wood. You can make one yourself by following the instructions from the picture.

With the right tools, you can crank one of these bad boys out in less than a day’s work. It’s definitely more of a niche item, but don’t be fooled into thinking that it’s not versatile! You can use one of these to display a bowling trophy, a prized-collectible action figure, a family photo that has to stand out from the rest, and even most foods that don’t taste like cake!
I built my first platform bed by following the steps mentioned in the tutorial and the end result was everything I expected. It was as beautiful as comfortable and strong. It only cost me around $60 to build this one from the scratch. And if I can build it, anyone can. What you need is a little bit of woodworking experience and a lot of confidence. Collect the items as suggested in the video and start working now.
Begin by cutting off a 10-in. length of the board and setting it aside. Rip the remaining 38-in. board to 6 in. wide and cut five evenly spaced saw kerfs 5/8 in. deep along one face. Crosscut the slotted board into four 9-in. pieces and glue them into a block, being careful not to slop glue into the saw kerfs (you can clean them out with a knife before the glue dries). Saw a 15-degree angle on one end and screw the plywood piece under the angled end of the block.
×