Furnishing and decorating your patio is not an easy task – but then again, it has to be done! Your patio is obviously one of the most important rooms in your home, as you can easily turn it into your little piece of Heaven, your “safe spot” in your home where you can retreat whenever you want to ignore the world and just spend some time alone all by yourself.
A small oak table is a very useful wooden item for every household. You can yourself make a nice, strong and beautiful oak table suitable for any purpose. See the image below. As you can see, it is a small, yet good enough table to be used as a coffee table, lamp stand, breakfast table, etc. You can also find many other design variants on the internet. Choose the one you want for yourself and start making it now.
Yes Seriously! You can build an easy bed frame yourself without any other’s help. As everyone knows the starting point of any bedroom is a gorgeous bed. However, you also need something that lets you enjoy peaceful slumber in comfort and warmth, but since the bed took as the focal point of the room, you may need something that looks really good too.
This tutorial shows the making of wooden hanging planter boxes, one of the easiest ways by using basic tools like woodcutters, hammer, drill and measuring tape. I made it at home for my creativity in easy steps. You can also make by cutting, assembling, add mesh and plastic, then attach to the boundary and fill the planter with your favorite flowers and plants.
Just as a bit of an aside, I’m fairly new to woodworking and I’ve been looking into some CNC routers for cutting for these projects. I came across something interesting. The guy on this page claims to have put together a homemade CNC router for less than $300. I’m curious to know what you think about it. If you’ve never heard of it and don’t have an opinion, then no problem; I thought I’d ask anyway.
Begin by cutting off a 10-in. length of the board and setting it aside. Rip the remaining 38-in. board to 6 in. wide and cut five evenly spaced saw kerfs 5/8 in. deep along one face. Crosscut the slotted board into four 9-in. pieces and glue them into a block, being careful not to slop glue into the saw kerfs (you can clean them out with a knife before the glue dries). Saw a 15-degree angle on one end and screw the plywood piece under the angled end of the block.