Building a wine rack is usually a very common beginner's woodworking plan. Creating a wine rack is an easy plan that can most of the time be completed in a day or half, depending on how large and detailed you would like it to be. And the better news is that this free wine rack plan will let you build you a great looking wine rack for much less than it would cost.
With a pencil and a protractor, divide the larger disc into 30-degree wedges to create 12 center lines for the bottle indents. Center and trace the smaller disc on top of the larger disc. Next, with a drill press, drill 3/8-in.-deep holes on the 12 center lines with the 1-7/8-in. Forstner bit, spacing them between the disc’s outer edge and the traced circle. Next, divide the smaller disc into 60-degree wedges and drill six more 3/8-in.-deep holes with the Forstner bit.
But they had to start somewhere too right. If you’re looking to get into it, here some simple woodworking ideas that can get you started. There are a lot of cool projects about some easy wood ideas from wooden desks, shelves wooden clamps, trays and decorative articles to coffee table plans, rocking chairs wine holders, clocks, fences, wall designs, bird houses, cutlery, coasters and what not, that you can try as beginners and they tell you how to do it step by step.
Prices, promotions, styles, and availability may vary. Our local stores do not honor online pricing. Prices and availability of products and services are subject to change without notice. Errors will be corrected where discovered, and Lowe's reserves the right to revoke any stated offer and to correct any errors, inaccuracies or omissions including after an order has been submitted.
These are indeed simple, and they look awesome to boot! I think I could make these look even nicer even better if I made some precision cuts for fine detailing. I was actually looking into that, and I found this page — the guy there says he was able to build a quality CNC router (for cutting) for about $300. Have you heard of the program he talks about? If you haven’t, no worries, but I thought I’d ask anyhow. Thanks again for these great beginner projects!
Begin by cutting off a 10-in. length of the board and setting it aside. Rip the remaining 38-in. board to 6 in. wide and cut five evenly spaced saw kerfs 5/8 in. deep along one face. Crosscut the slotted board into four 9-in. pieces and glue them into a block, being careful not to slop glue into the saw kerfs (you can clean them out with a knife before the glue dries). Saw a 15-degree angle on one end and screw the plywood piece under the angled end of the block.