We have a small dining room area in our farmhouse that is separate from the living room and kitchen. The area is much smaller in space than our last house. I was little confused that our typical rectangular farmhouse table was not going to cut it. So, I walked in I came to know that we needed to build a round dining table. So, I searched for a plan design idea and build a very own round farmhouse dining table. I was an amazing DIY plan, I just love it!
Making a garden arched footbridge out of some wood boards can be fun, hard working plan and also it’s quite rewarding. We are providing the project tutorial for how to build an arched footbridge without rails or having rails. If you take your hands of work and have some basic woodworking skills you can easily build this type of bridge. While this garden bridge is too small to walk over but it can make a really stunning addition to your lush yard or garden.
During the late Victorian era, wooden items for decoration started to attain popularity. Wood is having a significant role in our life. It is used to decorate every corner of our living places. Vases are among most stylish and beautiful items of wooden material. You can use wooden vases as a lamp, to make an attractive centerpiece of your table, to store all kitchen utensils in a vase and use as an accessory holder like decoration pieces. I make this wooden stylish vase at home easily and embellish with different decoration items that give a marvelous look to my room
A super simple iPad Dock/stand made out of a single block of wood features an angled groove which gets to support the tablet device and a cut in a hole to revise access to the home button of your iPad. It’s possible to drill an access channel in the stand through which you can run a charging cable, although this mini stripped back iPad stand may have very limited functions.
At your home, there must be a proper place for keeping a guitar as you have to take it with you while going out. Normally you get desperate when you are not finding your guitar. You always have a fear of breaking that guitar. Have you ever heard about a guitar holder? I found this online it by myself because I was desperately finding a proper place for keeping my guitar. So, I am sharing some of the pictures with you. Have a look at them.
Begin by cutting off a 10-in. length of the board and setting it aside. Rip the remaining 38-in. board to 6 in. wide and cut five evenly spaced saw kerfs 5/8 in. deep along one face. Crosscut the slotted board into four 9-in. pieces and glue them into a block, being careful not to slop glue into the saw kerfs (you can clean them out with a knife before the glue dries). Saw a 15-degree angle on one end and screw the plywood piece under the angled end of the block.