Working on one side at a time, glue and nail the side to the back. Apply glue and drive three 1-5/8-in. nails into each shelf, attach the other side and nail those shelves into place to secure them. Clamps are helpful to hold the unit together while you’re driving nails. Center the top piece, leaving a 2-in. overhang on both sides, and glue and nail it into place. Paint or stain the unit and then drill pilot holes into the top face of each side of the unit and screw in the hooks to hold your ironing board. Mount the shelf on drywall using screw-in wall anchors.
Make It: Help your child paint a square wooden dowel and wooden spool his favorite colors and allow to dry. Glue white string around the spool and adhere it near the bottom of the dowel. Attach a long string to the far end of the dowel and tie a magnet to the opposite end (magnetic barrels from the jewelry section of the craft store work well). Make clothespin "fish" by painting them fun colors with pink lips. Let paint dry and help your child glue on sequin scales and googly eyes. Now he'll be ready to go fishing!
Make this Wooden DIY dog bed and give a treat to your dog. I searched it on the internet a couple of months back when I was looking to buy a good bed for my dog. Besides, the dog food table, I also tried to do this by myself and I succeeded. It isn’t that difficult to make as it looks. It just took me 2 days to complete this item and my dog loves it. He doesn’t sleep anywhere else now and this has decreased my tensions regarding my dog. If I can make this item, surely you can make it too.
Through learning, you can make this simple and designing photo frames. I spent whole one week to learn the proper way to carve the ends and give it an attractive look but believe me it was worth it. A few weeks back when I searched this on the internet, I never thought I could make it until I started it and completed it in just hours. The carving took extra time, but besides that, it is easy to make. If I can make this, surely you can also. So make these interesting photo frames and hang them on your walls.
With a pencil and a protractor, divide the larger disc into 30-degree wedges to create 12 center lines for the bottle indents. Center and trace the smaller disc on top of the larger disc. Next, with a drill press, drill 3/8-in.-deep holes on the 12 center lines with the 1-7/8-in. Forstner bit, spacing them between the disc’s outer edge and the traced circle. Next, divide the smaller disc into 60-degree wedges and drill six more 3/8-in.-deep holes with the Forstner bit.